ENGINEERING SERVICES
One team, from first sketch to serial delivery.
Electronics, embedded software, PCB layout, mechanics, cabling, test and compliance — held by the same engineers, in the same building, on the same project. Come in at any stage. Hand over at any stage.
In-house lab
Electronics, EMC and motor testing on site — problems found before certification, not after.
ISO 9001 & 14001
Certified management systems governing documentation, revisions and traceability.
Altium, OrCAD, KiCad
We work in your toolchain and hand over sources, libraries and production data.
HOW A PROJECT RUNS
Five phases. You choose where we start.
Most customers arrive with either a specification, a problem or a resource gap. The work below is the same either way — only the entry point changes.
01
Pre-study & analysis
We establish what the application actually demands — torque, voltage, duty cycle, thermal envelope, EMC environment, cost target — and what that rules in or out. Often this ends with the honest answer that a standard product will do.
02
Design
Hardware, firmware, board and enclosure are designed together, because in power electronics they fail together. PCB layout is a dedicated discipline here — it decides EMC, thermal behaviour, safety clearance and production cost long before the first board is built.
03
Prototype
Short iterations against real hardware. We build, measure, change and rebuild — and we keep the schematic and layout libraries so the next revision starts from a known state rather than from scratch.
04
Verification
Our own electronics, EMC and motor lab means pre-compliance testing happens during development, not as a surprise at the certification house. We advise on which directives and standards apply, and what evidence you will be asked for.
05
Series production & lifecycle
Design for manufacture, complete production documentation, and support through ramp-up and the years after it — including component obsolescence, revisions and second-source work.
SELECTED WORK
A few projects we took the whole way.
HANDHELD POWER TOOLS
Motor drive for a handheld stone cutter
Developed a complete motor drive — hardware, software, layout and production documentation. Supported the customer all the way into serial production.
SUBSEA ROBOTICS
Intelligent power management for an underwater robot
Developed a complex system to handle sudden large power demands in an underwater robot. Hardware, software and layout, delivered with complete manufacturing documentation.
RUGGEDISED COMMUNICATIONS
Modern communication solution, delivered in series
Everything from schematic and layout to enclosure, cabling, EMC measurement at an accredited institute, labels and packaging, plus complete CE documentation. The customer supplied the software; we did the rest, handed over full manufacturing data and also delivered the product in series.
ENERGY
High-reliability protection circuit for emergency breaker closing
A protection circuit that closes a breaker in an emergency, where reliability requirements were very high. We developed the board including layout, the embedded software and an EMC-friendly enclosure, and handed over complete manufacturing documentation.
Our own 300 sqm electronics, EMC and motor testing capability sits alongside the design desks. That shortens the loop between a measurement and a design change from weeks to hours, and it means a board is verified before it goes to a certification house.
Work is run under ISO 9001 and ISO 14001 certified management systems, so documentation, revision control and traceability follow the same rules on every project.
THE LAB
Engineering. Build. Test. Repeat.
CAPABILITY INDEX
Everything we do, in one list.
Electronics
Circuit design
DC/DC converters
Motor drives
Magnetics
Sensor interfaces
PCB layout
Schematic & footprint libraries
Software & control
Embedded firmware
Motor control algorithms
Fieldbus & communication
Configuration & diagnostics tools
Functional safety support
Mechanics & cabling
Mechanical design
Enclosures & thermal solutions
Cable & harness design
Connector selection
Design for manufacture
Test, compliance & project
Pre-compliance EMC testing
Environmental testing
Motor testing
Design & failure analysis
Compliance advice
Project management
Support & maintenance
Start with a
30 minute technical brief.
Tell us what you are trying to build, improve or replace. We will connect you with an engineer who understands the application — typically within 24–48 hours.